The Challenges to Swim Spa Covers

Swim Spas represent special challenges when it comes to covering them.
We can all concur that the swim spa has to be covered when not in use for all the same reasons a hot tub requires a cover. The obstacle is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot more difficult.
Getting a brand-new swim spa is an exciting event in life. You’re anticipating the workout you’ll get from using it. Perhaps you’re a little relieved to have actually finally made a selection from the various models you took a look at. At any rate, you probably weren’t thinking much about the cover you would use.
Generally, the cover that comes home with your new purchase will be a 4 section rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Until it starts to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a style defect. Integrated in obsolescence due to the fact that as quickly as it is placed in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any difference. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are very small as they rise from the water surface. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes trapped in the cover.
It happens gradually and on a Swim Spa Cover which is made from private sections, at varying speeds. So eventually you’ll discover a couple of of the sections are really getting heavy. The bar lifters on the ends of the swim spa aren’t much help since you still have to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com created a new style for their Swim Spa Covers
Instead of using a number of foam panels to build Swim Spa Covers that will ultimately wind up in some landfill, they created one that utilizes air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, will not blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you intend to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to buy today, bookmark this site so you can find it again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *