The Challenges to Swim Spa Covers

Swim Spas represent special difficulties when it comes to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an amazing occasion in life. You’re looking forward to the exercise you’ll obtain from using it. Maybe you’re a little relieved to have finally made a selection from the different designs you took a look at. At any rate, you most likely weren’t thinking much about the cover you would use.
Generally, the cover that gets back with your brand-new purchase will be a four area rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design flaw. Integrated in obsolescence because as quickly as it is positioned in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper won’t make any difference. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The molecules of steam are really small as they increase from the water surface. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.

It happens gradually and on a Swim Spa Cover which is made of individual areas, at varying speeds. So ultimately you’ll discover a couple of of the areas are really getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance because you still need to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a new style for their Swim Spa Covers
Instead of using several foam panels to develop Swim Spa Covers that will eventually wind up in some land fill, they developed one that utilizes air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the seams either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to buy today, bookmark this site so you can discover it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *